DogHouse STuff

Things You'll Need:
Nine 2-by-4-by-30 inch boards
Four 2-by-4-by-26 inch boards
Five pieces of 1/2-inch treated plywood, 30 by 30 inches
One piece 1/2-inch treated plywood, 15 by 30 inches
Saw
3/4-inch nails, 200
3-inch nails, 30
Screws 6 half-inch
Three 1-inch hinges
Two latches, such as eye-and-hook
Hammer
Screwdriver





•Cut the 2-by-4 inch boards and plywood as indicated in supplies needed to build a doghouse with a flat roof.

•2
Frame 4 of the 2-by-4 inch boards into a square frame by placing 2 of the 30-inch boards across from each other and 2 of the 26-inch boards 2 inches inside the edges of the 30-inch boards so that the edges are smooth. Repeat this process to create a second square.

•3
Hammer 3-inch nails into the 30-inch boards so that the nails go into the 26-inch boards, securing the square frames. Be sure to use at least 2 nails in each board.

•4
Hammer 3-inch nails into one 2-by-4-by-30 inch board into the inside of each corner, creating a cube. Also, hammer one 30-inch board 15 inches from one corner to create the door of the doghouse.

•5
Attach the 1/2-inch treated plywood squares using the 3/4-inch nails to the bottom of the cube creating the floor, the top of the cube creating the roof, and three sides of the cube. Do not yet attach the plywood to the side of the cube where you will make the door; this is the side that has a board attached at the 15-inch mark.

•6
Use the three hinges and screws to attach the smaller piece of 1/2-inch treated plywood, 15-by-30 inches, to the corner of the doghouse on the side you left open. Place the two latches on the board at the 15-inch mark. This will allow you to open the doghouse if necessary to clean it or to add bedding



Read more: How to Build a Doghouse With a Flat Roof | eHow.com http://www.ehow.com/how_4883005_build-doghouse-flat-roof.html#ixzz16AaS4jOw

Read more: How to Build a Doghouse With a Flat Roof | eHow.com http://www.ehow.com/how_4883005_build-doghouse-flat-roof.html#ixzz16AaM0Fbz

http://www.woodvendors.com/index.php/lumber.html



8 pieces to make a fence (a piece of fence) to hold a dog. (if i wanted to ahold dogs and sell them (like a animal control place). a total amount of money 172 dollars. thats 0.48 cents board a foot for a wooded a fence. so far the cheapest. a five piece by 2 piece.

4x8 ceder 67 dollars..... http://www.hooverfence.com/wood/dog-ear-spaced.htm


18dollars for wire mesh fence
t post anywhere from 9 dollars to 17dollars.